IBM xSeries 365, Option Installation Manual

Page: 41 / 68

Attention: To avoid breaking the VRM retaining clips or damaging the
VRM connectors, open and close the clips gently.
b. Turn the VRM so that the VRM keys align correctly with the connector.
c. Insert the VRM into the connector. Firmly press the VRM straight down into
the connector by applying pressure on both ends of the VRM
simultaneously. The retaining clips snap into the locked position when the
VRM is firmly seated in the connector. If there is a gap between the VRM
and the retaining clips, the VRM has not been correctly inserted; open the
retaining clips, remove the VRM, and then reinsert it.
12. Reinstall the microprocessor tray in the server:
a. Make sure the microprocessor-tray release latch is open; then, push the
microprocessor tray into the server.
b. Close the tray levers and make sure they are securely latched.
c. Press the microprocessor-tray release latch down.
d. Reinstall the fans and memory cassette in the server.
13. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 35.
Installing a hot-swap power supply
The following notes describe information that you must consider when installing a
hot-swap power supply in the server:
v
The server comes with a minimum of one power supply and supports up to two
power supplies.
v The power supplies are numbered from left to right (1 to 2) as viewed from the
rear of the server. Power supplies must be installed in the following sequence:
power supply 1, then power supply 2.
v
If you install or remove a power supply, observe the following precautions:
Chapter 2. Installing options
29