IBM WebSphere DataPower 7198, Installation And User Manual

Page: 77 / 88

– From the show interface command.
– From the WebGUI: click STATUS
→
IP Network
→
Ethernet Interfaces .
You must turn off the appliance before replacing the Ethernet module.
To replace an Ethernet module:
v If the appliance is not turned off, perform a graceful shutdown by pressing the
power button on the front of the chassis. Because the appliance does not provide
feedback of a graceful shutdown, wait until the power LED is no longer
illuminated.
v
Unplug all power cords.
v
Grasp the blue latch and pull outward.
v
Pull the lever toward you to pull out the Ethernet modules, as shown in
Figure 27.
v
Set aside the Ethernet module.
Attention: Ensure that the gold connectors at the rear of the module do not
come into contact with your hands or with the packing material as you unpack
the replacement module. Avoid damaging the gold connectors against the
chassis as you insert the replacement module.
v
Unpack the replacement module.
v
Carefully align the module, and insert into the appliance.
v
Push the Ethernet module forward until the module is in place.
v
Push the blue latch back in place
v
Plug in all power cords.
v
Turn on the appliance by pressing the power button located on the front of the
appliance.
v Verify that the power LED is illuminated.
After replacing the module, you can verify that the new module is working if:
v
You are able to connect to the network after you plug in the cable and the link
status LED is illuminated.
v
The fault LED light is not illuminated.
Figure 27. Removing an Ethernet module
Chapter 7. Removing or replacing the appliance or parts
57