IBM Ultrium Gen 6, Installation And User Manual

Page: 74 / 118

If you encounter a media-related problem, see “Function code E: Test cartridge and
media” on page 35.
Replacing the tape drive
Use this information to replace the tape drive.
The drive is a Tier 1 customer replaceable unit (CRU). Replacement of Tier 1 CRUs
is your responsibility. If IBM installs a Tier 1 CRU at your request, you will be
charged for the installation.
For more information about the terms of the warranty and getting service and
assistance, see the
Warranty information document that came with the tape drive.
If you are instructed to return a component, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
The following table lists the replaceable components.
Table 11. CRU and Option part numbers
Description CRU part number Option part number
IBM Internal Half High LTO
Gen 6 SAS Tape Drive 35P1049 00D8924
SAS cable (internal) 49Y9901 N/A
Tape drive rail (order two for
tape drive installation) 41Y7711 N/A
Screw pack 42C3934 N/A
To replace your tape drive, complete the following steps:
1. Remove the replacement unit from its packaging.
2.
Locate the repair identification (RID) tag that is included with the replacement
unit.
3. Write down the serial number of the failed unit on the RID tag.
4. Affix the repair tag to the rear panel of the replacement unit (below the serial
number label).
5. Place the failed unit into the packaging of the replacement unit.
6. Follow the instructions for returning the failed unit that are included with the
replacement unit.
56
IBM Half High LTO Ultrium Gen 6 Internal SAS Tape Drive: Installation and User's Guide