IBM TS3400, Maintenance Information

Page: 235 / 295

Chapter 9. Check, Adjust, Remove, and Replace Procedures
9-41
Figure 9-47. Cartridge magazine release plate
15. Unhook the circuit wiring from the hook ( in Figure 9-47) located on the top of
the power supply housing.
16. Disconnect the three flat cable connectors and the two pin connectors on the front
of the back board (Figure 9-48). Release the flat cable connector lock by pulling
the lock tab ( in Figure 9-49) on the left side of the connector towards you, and
then withdraw the flat cable out of the connector.
Note: See Figure 9-49 for a close-up view of the flat cable as it mates with the
connector. The cable contacts are aligned with the connector contacts and
are held in place by pressing the slide lock in to wedge the cable and
connector together.
E0
5
Enc
a
34z0013
FC SH
O
RT
-W
AV
E
4Gb
/ S
EC
PO
RT
0
PO
RT
1
1
2
2
1