IBM TotalStorage, Installation Manual

Page: 15 / 91

Perform the following internal machine checks before you install the SAN Volume
Controller:
1.
Check for any non-IBM changes that might have been made to the machine. If
any are present, obtain the “Non-IBM Alteration Attachment Survey” form
number R009, from the IBM branch office. Complete the form and return it to
the branch office.
2. Check the condition of the inside of the machine for any metal or other
contaminants, or any indications of water, other fluid, fire, or smoke damage.
3. Check for any obvious mechanical problems, such as loose components.
4. Check any exposed cables and connectors for wear, cracks, or pinching.
Related topics:
v
“Inspecting the SAN Volume Controller for unsafe conditions” on page xi
v
“External machine checks” on page xii
Checking the grounding of the SAN Volume Controller and the
uninterruptible power supply
This topic tells you how to check the grounding of the SAN Volume Controller.
Figure 1 shows the connectors for the SAN Volume Controller and the
uninterruptible power supply.
Steps:
Perform the following steps to ensure that the SAN Volume Controller is properly
grounded:
1. Ensure that all power is removed.
2.
Ensure that the power cable
1
is plugged into the uninterruptible power
supply. Also ensure that the other ends of the power cable are connected to the
power supply in the rack. See Figure 1.
2 1
3
Figure 1. Power cable and signal sockets
About this guide
xiii