IBM TotalStorage Ultrium 3580 L23, Setup And Operator Manual

Page: 80 / 149

Function Code 2: Update Tape Drive Firmware from FMR Tape
Attention: When updating drive firmware, do not power-off the 3580 Ultrium 2
Tape Drive until the update is complete or the firmware may be lost.
Function Code 2 loads updated drive firmware from a field microcode replacement
(FMR) tape. After the update is complete, activate the new firmware by turning the
power off, then on again.
1. Make sure that no cartridge is in the drive.
2. Make sure that the following message appears on the message display (you
may need to turn the power off, then on again for the message to appear):
Ultrium Tape Drive
Drive Empty
3. Within two seconds, press the unload button 3 times. The status light becomes
solid amber and the following message displays (indicating that the tape drive
is in maintenance mode):
Maint Mode: Select
Exit Maint Mode
Note: If a cartridge is in the tape drive, it will eject the first time that you press
the unload button and the drive will not be placed in maintenance
mode. To continue placing the drive in maintenance mode, perform the
preceding step.
4. Press the unload button once per second until
2
appears in the single-character
display and the following message displays. (If you cycle past the desired code,
press the unload button once per second until the code redisplays.)
Maint Mode: Select
Update Drive FW
5. Press and hold the unload button for 3 or more seconds, then release it to select
the function. Immediately after the following message displays, insert the FMR
tape cartridge (or the tape drive exits maintenance mode).
Update Drive FW
Load Drv FMR Tape
After you insert the FMR tape cartridge, the flashing
C
in the single-character
display changes to
2
and the following message displays:
Update Drive FW
Tape Loading = = = >
followed by:
Update Drive FW
Reading = = = >
The tape drive loads the updated firmware from the FMR tape into its erasable
programmable read-only memory (EPROM) area.
64
IBM 3580 Ultrium Tape Drive Setup and Operator Guide