IBM TotalStorage L10, Cli Reference Manual

Page: 51 / 96

Chapter 2. Configuration menu (root/config)
39
Network configuration menu (root/config/network)
The Network configuration menu displays the current network settings and provides
commands for configuring the switch’s network settings.
Menu commands
Hardware reset (root/config/network/reset)
This command resets the switch.
To reset the switch:
1. From the Network configuration menu (root/config/network), type
reset
and press
E
NTER
.
If any changes have been made to the switch configuration, a message appears
confirming the request to save the current configuration.
2. To save changes and reset the switch, type
y
and press E
NTER
.
To reset the switch without saving changes, type
n
and press E
NTER
.
To cancel the request to reset the switch, type
c
and press E
NTER
.
Displaying network settings (root/config/network/show)
This command displays the current and saved network settings for the switch, including
the IP address, gateway, and netmask. The Current settings are the settings used by the
switch at this time. The New settings are the settings that will be used by the switch the
next time it is reset.
To view the network settings:
From the Network configuration menu (root/config/network), type
show
and press
E
NTER
.
The default IP settings are:
• IP Address: 192.168.1.129
• Netmask: 255.255.255.0
• Gateway: 192.168.1.1
Table 21. Network configuration menu commands
Command Description
Additional
Information
1. reset Resets the switch. See page 39.
2. show Displays the current network settings. See page 39.
3. ip Configures the IP Address setting. See page 40.
4. mask Configures the network mask setting. See page 40.
5. gateway Configures the default gateway settings. See page 40.
6. .. Returns to the previous menu. See page 10.
7. ? Displays additional information on a command. See page 10.