IBM TotalStorage L10, Cli Reference Manual

Page: 52 / 96

2006 Model L10 Storage Switch
40
Configuring the IP address setting (root/config/network/ip)
This command configures the IP address for the switch. The IP address format should
be separated by periods. For example, 196.168.1.129.
To change the IP address setting:
1. From the Network configuration menu (root/config/network), type
ip
and press
E
NTER
.
The switch’s current IP address setting appears in brackets before the command
prompt.
2. Type the new IP address and press E
NTER
.
The switch’s IP address is now saved and becomes active once the switch is reset.
Configuring the network mask setting (root/config/network/mask)
This command configures the network mask setting for the switch. These changes will
become active once the switch is reset. The network mask format should be separated
by periods. For example, 255.255.255.0.
To change the network mask setting:
1. From the Network configuration menu (root/config/network), type
mask
and press
E
NTER
.
The switch’s current network mask setting appears in brackets before the command
prompt.
2. Type the new network mask setting and press E
NTER
.
The switch’s network mask setting is saved and becomes active once the switch is
reset.
Configuring the gateway setting (root/config/network/gateway)
This command configures the default gateway setting for the switch. These changes will
become active once the switch is reset. The network mask format should be separated
by periods. For example, 196.168.1.1.
To change the default gateway setting:
1. From the Network configuration menu (root/config/network), type
gateway
and press
E
NTER
.
The switch’s current default gateway setting appears in brackets before the command
prompt.
2. Type the new default gateway setting and press E
NTER
.
The switch’s default gateway setting is saved and becomes active once the switch is
reset.