IBM TotalStorage L10, Cli Reference Manual

Page: 19 / 96

Chapter 1. Introduction
7
Root menu (root)
The Root menu is the CLI’s main menu. This menu is the first menu displayed after
entering the password and logging in to the CLI.
Menu commands
Hardware reset (reset)
This command resets the switch.
To reset the switch:
From the Root menu, type
reset
and press E
NTER
.
If changes have been made to the switch configuration, a message appears asking if the
current configuration should be saved.
To save changes and reset the switch, type
y
and press E
NTER
.
To reset the switch without saving changes, type
n
and press E
NTER
.
To cancel the request to reset the switch, type
c
and press E
NTER
.
Help (?)
This command displays the help description for a specific command.
To display help for specific command:
Type
? <command>
and press E
NTER
.
Enter the command using one of the following methods:
• Type the actual command text. For example, under the Show menu, to view help for
the sysinfo command: type
? sysinfo
and press E
NTER
.
• Type the number of the command. For example, under the Show menu, to view help
for the sysinfo command: type
? 6
and press E
NTER
.
• Type the first few letters of the command. For example, under the Show menu, to view
help for the sysinfo command: type
? sys
and press E
NTER
.
Table 2. Root menu commands
Command Description Additional Information
1. config Displays the Configuration sub-menu. See page 9.
2. diag Displays the Diagnostics sub-menu. See page 49.
3. show Displays the Show sub-menu. See page 55.
4. fw Displays the Firmware sub-menu. See page 63.
5. reset Resets the switch. See page 7.
6. ? Displays additional information on a
command. See page 7.