IBM ThinkPad i Series, User Manual

Page: 9 / 82

Note: The adapter screws are knurled to assist with installing the adapter
by hand. A small screwdriver may be required to fully seat the
screws for installation.
Note: It is important to fully seat the side screw to prevent the drive from
becoming wedged in the bay.
5. Tighten the back screw
B
clockwise until the adapter is snug against the
drive. See Figure 1-3.
Notes:
1. To install an Ultrabay enhanced slim drive in an Ultrabay 2000 bay, insert it
into the enhanced drive adapter first. Then you can install the enhanced
drive adapter in either of the following places:
v
In the Ultrabay 2000 of a qualified ThinkPad computer, except a
ThinkPad T40 or T50 Series computer. To obtain a list of qualified
computers, visit the Web site at
http://www.ibm.com/support, and search under
″
Enhanced Drive
Adapter.
″
v
In the Ultrabay 2000 of a ThinkPad Dock II.
2. To install a device into the Ultrabay 2000 bay of your ThinkPad computer,
or to remove it, refer to Access IBM, the on-board help system for the
computer.
Uninstalling the enhanced drive adapter
To uninstall the enhanced drive adapter, complete the following procedure:
1. Loosen the screws, shown in Figure 1-3, by turning them counterclockwise.
Note: The adapter screws are knurled to assist with uninstalling the
adapter by hand. A small screwdriver may be required to loosen the
screws.
B
A
Figure 1-3. Adapter screws
About the ThinkPad Enhanced Drive Adapter for Ultrabay 2000
1-3