1
3100-A2-GK42-10
October 1997
SNMP LAN Adapter for Ethernet Quick Installation
Document Number 3100-A2-GK42-10
October 1997
Installation Steps
Follow these steps to install the SNMP LAN Adapter. See the SNMP LAN Adapter Owner’s Manual if you
require more information.
1. Connect the LAN Adapter to your network. You require a 10BaseT or Thinnet cable. This cable is not
included. If you use a Thinnet cable, you must change jumpers inside the LAN Adapter. See the Owner’s
Manual.
2. Select one of the two cables provided with the SNMP LAN adapter using Table 1. One end of each cable
is marked LANA. The other end of the cable is marked COM or AUX.
3. Insert the end of the cable marked LANA into the UNIPORT socket of the LAN Adapter. Connect the
other end of the cable into the appropriate port of an SNMP-managed device, using the included DB25
adapter if necessary.
4. Configure the IP address of the managed device. The address must be on the same subnet as the LAN
Adapter.
PARALLEL PRINTER
UNIPOR
T
ETHERNET NETW
ORK
PO
WER
10BaseT
Thinnet
Po
rt 1
Ethernet
Hub
8-Wire
Twisted Pair
(not included)
Managed
Device
AUX
LANA
COM
COM
Cable
AUX
Cable
LANA
or
AC Outlet
Power Cord
(connect last)
Unused
For Thinnet
LAN only – see
Owner’s Manual
DB25 Adapter
(if required)
97-15592
TM
