DIL32/PLCC32 ZIF-CS
U
niversal adapter, assigned for devices in PLCC32/LCC32 (for example EPROMs, EEPROMs, FLASHs, Serial FLASHs)
support also LCC32 packages
T
his adapter is designed for mass-production purposes
O
perating (mechanical) warranty of ZIF socket - 10,000 actuations
S
ocket -
ZIF PLCC32, ClamShell type
Bottom -
2 rows, 2x 16 pins, square, 0.6x0.6mm, rows spacing 600mi
l
Adapter manual
Insert adapter to the device programmer ZIF socket according to the picture placed near of it. If you have
some doubts about
orientation of this adapter in device programmer ZIF socket, it is valid general rule, the
orientation of the text of title is the
same as the text on the top of the device programmer.
Open the adapter ClamShell ZIF socket. Insert the device into it (place device on contacts). The right
position of the
programmed device in adapter ZIF socket is show at picture near (mainly left above) the
adapter ZIF socket.
Visually check interconnection between device and adapter ClamShell ZIF socket. If everything looks OK,
close it and now,
device is ready for programming.
Be careful, because the incorrect insertion of adapter to the device programmer ZIF socket or device to
the adapter
ClamShell ZIF socket can damage the programmed device.
To take out the device, open adapter ClamShell ZIF socket and remove device from it.
When you finish work with adapter, remove it from the device programmer ZIF socket.
Do not directly touch the pins of the adapter and adapter ZIF socket, because dirt may cause errors during
programming of
device.
For handling with the device we recommended to use a vacuum pick up tool.
Operation conditions: operating temperature 5°C ÷ 40°C (41°F ÷ 104°F), operating humidity 20%..80%,
non condensing.
The ZIF socket on the DIL32/PLCC32 ZIF-CS can accommodate the LCC32 package. A shim must be
used to make up the
difference in thickness between the PLCC and LCC packages. Therefore LCC
thickness varies, the shim thickness will need
to be determined for current LCC device by
Shim thickness = 4,6 mm (0.181 inch) - LCC device thickness
and cut to a size of 12mm (0.47inch) by 12mm (0.47inch). It should be affixed to the inside of the cover of
the socket. Test
close the socket, without a device, to confirm the shim does not interfere with the
interlocking parts of the socket.
If programming yields isn't 100% when using programming adapter or if some unreliability appears, try to connect one
22nF-100nF multilayer capacitor (that meet the EIA X7R or Z5U specification) between leads of adapter connected to pins
VCC and GND pins of programmed chip.
