Check that the leader pin is properly seated (see 2 in
).
If you suspect that the cartridge was mishandled but it appears usable, copy any data onto a good cartridge immediately for possible data recovery. Discard the
mishandled cartridge.
Review handling and shipping procedures.
Handling the cartridges
About this task
Do not drop the cartridge. If the cartridge drops, slide the cartridge door back and ensure that the leader pin is properly seated in the pin-retaining spring clips (see
2 in
). If the leader pin is dislodged, go to
Repositioning or reattaching a leader pin
.
Do not handle tape that is outside the cartridge. Handling the tape can damage the tape's surface or edges, which might interfere with read or write reliability.
Pulling on tape that is outside the cartridge can damage the tape and the brake mechanism in the cartridge.
Do not stack more than six cartridges.
Do not degauss a cartridge that you intend to reuse. Degaussing makes the tape unusable.
Examples of cartridge problems
Several examples of cartridge problems.
About this task
Example: Split cartridge case (see
)
The cartridge's case is damaged. There is a high possibility of media damage and potential loss. Perform the following steps:
Procedure
1. Look for cartridge mishandling.
2. Use the IBM Leader Pin Reattachment Kit (part number 08L9129) to correctly seat the pin (see
Repositioning or reattaching a leader pin
). Then, immediately use
data recovery procedures to minimize chances of data loss.
3. Review media-handling procedures.
Results
Example: Improper Placement of Leader Pin (see
)
1. Look for cartridge damage.
2. Use the IBM Leader Pin Reattachment Kit (part number 08L9129) to correctly seat the pin (see
Repositioning or reattaching a leader pin
). Then, immediately use
data recovery procedures to minimize chances of data loss.
Repositioning or reattaching a leader pin
Information about repairing your tape cartridges: repositioning or reattaching the leader pins.
Attention: Use a repaired tape cartridge only to recover data and move it to another cartridge. Continued use of a repaired cartridge might void the warranties of the drive
and the cartridge.
If the leader pin in your cartridge becomes dislodged from its pin-retaining spring clips or detaches from the tape, you must use the IBM Leader Pin Reattachment Kit (part
number 08L9129) to reposition or reattach it. (Do not reattach the pin if you must remove more than 7 meters (23 feet) of leader tape). The sections that follow describe
each procedure.
TS2900 Tape Autoloader
85
Summary of Contents for System Storage TS2900
Page 1: ...TS2900 Tape Autoloader IBM...
