IBM System Storage TS2900, Manual

Page: 74 / 130

2. Turn the library over and attach the feet 1 to the designated locations on the bottom of the library ( Figure 7 ). Return the library to the upright position.
Figure 7. Attaching the feet
3. Position the deskside cover 2 in the correct orientation over the library chassis and attach the cover to the library with 3 flat-head screws 6 on each side ( Figure
8 ).
Figure 8. Attaching the cover to the library chassis (side screws)
4. Attach the deskside cover with the 2 large pan-head screws 4 on the rear of the library ( Figure 9 ).
Figure 9. Attaching the cover to the library chassis (rear screws)
5. Place the library in the wanted desktop location.
Important: Do not place the library on its side. Do not stack objects on top of the library.
6. Remove the accessor locking screw 1 .
Figure 10. Removing the accessor locking screw
7. On the rear panel of the library:
a. Connect the SAS host interface cable.
b. Connect the Ethernet cable.
c. Connect the power cable from the library power supply. Route all cables through the hook-and-loop fastener strap.
d. Power ON the library by toggling the power supply switch to the ON (|) position.
8. Insert the cartridge magazine if previously removed.
TS2900 Tape Autoloader 69