IBM SYSTEM STORAGE EXP3000 - INTEROPERABILITY MATRIX 10-19-2010, Manual

Page: 44 / 64

Removing the bezels
Right bezel
Left bezel
Handles
To remove either the left or right bezel, complete the following steps:
1. If the EXP3000 is on a table or other flat surface, elevate the EXP3000 front
slightly or extend the front over the table edge.
2. Grasp the handle on the front of the bezel and pull until the bezel is clear of the
bottom tab on the chassis flange.
3. Lift the bezel off the chassis flange.
Installing the bezels
To install either the left or right bezel, complete the following steps:
1. Fit the cutout that is on the top of the bezel over the tab on the chassis flange.
2. Rotate the bezel down until it snaps into place. Make sure that the inside
surface of the bezel is flush with the chassis.
Replacing the release tab on an ESM or power supply
The miscellaneous hardware kit contains two replacement release tabs: one for a
power supply and one for an ESM or ESM filler panel. Obtain a miscellaneous
hardware kit if you have to replace a release tab (see Table 4 on page 26).
ESM release tab
Power-supply release tab
Alignment pins
Alignment pins
Arrow
Arrow
32
System Storage EXP3000: Installation, User’s, and Maintenance Guide