IBM System Storage DS4000 FC, Installation And User Manual

Page: 29 / 84

ds4hb003
1
2
3
4
Components shown in Figure 2:
1. Yellow, Green, and Amber LEDs for port 1
2. Port 1 (top), port 2 (bottom)
Note: Port 2 and LEDs for port 2 are for the dual port FC 4Gbps PCI-X Adapter
only.
3. Yellow, Green, and Amber LEDs for port 2
4. Serial number label
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static-protective package until
you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and possibly damage the
device.
v
While the device is still in its static-protective package, touch it to an unpainted
metal part of the system unit for at least 2 seconds. (This drains static electricity
from the package and from your body.)
v
Remove the device from its package and install it directly into your system unit
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
Figure 1. FC 4Gbps PCI-X Adapter serial number label
Chapter 1. Preparing and installing the IBM System Storage DS4000 FC 4Gbps PCI-X Single/Dual Port HBA
3