IBM SAN512B-6, Installation, Service And User Manual

Page: 55 / 286

Procedure
1.
Attach the rear tray (with or without adapter, as required) to both rack rails.
Orient the tray (refer the following figure) and use nine screws (Item E) for
each rail.
2. Attach the front tray to both rack rails. Orient the tray (Figure 3) and use nine
screws (Item E) for each rail.
3. Verify that the rear edge of the front tray is seated into the front edge of the
rear tray.
1 - Tray, rear, mid-mount, chassis
2 - Adapter, rear, mid-mount, right
3 - Adapter, rear, mid-mount, left
4 - Screws
Figure 10. Attaching the rear tray to the rack rails
Chapter 3. Mounting the Device
31