IBM SAN384B-2, Installation, Service And User Manual

Page: 50 / 190

4. Remove the port side exhaust kit, hardware accessory kit, chassis door, cable
management finger assemblies, and foam from the top of the chassis. Remove
the loose foam blocks from the corners of the chassis. Remove the anti-static
plastic from the chassis.
5. Place the kits and other installation pieces near the installation.
6. Move the lift tool next to the plastic shipping tray at the blower and power
supply end of the chassis. Position the lift tool with its left side next to the
shipping tray (see Figure 5).
7. Using the lift tool winch mechanism, adjust the height of top of the load plate
to slightly below the bottom surface of the chassis.
8.
Set the lift tool brake.
9. Carefully slide the chassis across the foam blocking in the shipping tray and
onto the center of the load plate. Do not use any of the handles on the
blowers or power supplies to move the chassis.
10. Attach the lift tool retention straps to secure the chassis to the load plate. This
is particularly important if you will be moving the chassis across any uneven
floor, or will be raising the chassis more than 45 cm (18 inches).
11. For safety considerations during moving, lower the load platform to its lowest
position.
12. Release the lift tool brake, and carefully move the chassis near the cabinet for
installation.
Installing the port-side exhaust kit
Complete the following instructions to install the port-side exhaust kit in a
2109-C36 cabinet before installing the SAN384B-2 chassis.
Figure 5. Lift tool positioned next to the chassis on the shipping tray
18
SAN384B-2 Installation, Service, and User Guide