IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 65 / 110

6
Communication port
7
Load-segment 2 receptacle
2. Place the other end of the power cables into the load-segment 2 receptacles
7
on the 2145 UPS-1U.
DANGER
You have already switched on the 2145 UPS-1U. The output sockets of the
2145 UPS-1U are live.
3.
Plug the signal cable into the serial connector
3
located on the SAN Volume
Controller 2145-CG8 node.
4. Place the other end of the signal cable into the communication port
6
on the
2145 UPS-1U.
Results
The SAN Volume Controller 2145-CG8 power is now connected to the 2145
UPS-1U.
Installing the SAN Volume Controller 2145-CG8 cable-retention
brackets
Two power cords run from the uninterruptible power-supply to each of the two
SAN Volume Controller 2145-CG8 power supplies. To anchor the power cords,
install the two cable-retention brackets on the back of the SAN Volume Controller
2145-CG8.
About this task
The cable-retention brackets install without tools, as shown in Figure 33.
To attach the brackets, perform the following steps:
Procedure
1. Loosely install the cable-retention bracket on a power cord by slipping the
power cord into the notch on the rear of the bracket.
1
2
Figure 33. SAN Volume Controller 2145-CG8 cable-retention brackets
Chapter 2. Installing the SAN Volume Controller 2145-CG8 hardware
37