IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 60 / 110

Note: Make sure that the junctions on the arm, as shown by
1
in Figure 27,
are facing the SAN Volume Controller 2145-CG8.
Place the cable management arm on the support arm. Pull out both
cable-management-arm pins and then slide the cable-management-arm tabs into
the slots on both the inside and the outside of the slide rail. Push the tabs until
they snap into place.
3.
Adjust the location of the cable management arm, as shown in Figure 28 on
page 33.
1
Figure 27. Installing the cable-management arm
32
SAN Volume Controller: Model 2145-CG8 Hardware Installation Guide