Table 13. Normal LED states (continued)
Green LED
Yellow LED
State
On
4 fast flashes
16 Gbps link rate: normal, link active
Power-on-self-test (POST) conditions and results are summarized in Table 14. These states can be used to
identify abnormal states or problems.
Table 14. POST conditions and results
Green LED
Yellow LED
State
Off
Off
Wake-up failure of the adapter board
Off
On
POST failure of the adapter board
Off
Slow flash
Wake-up failure monitor
Off
Fast flash
Failure in post
Off
Flashing
Postprocessing in progress
On
Off
Failure while functioning
On
On
Failure while functioning
Slow flash
Off
Normal, link down
Slow flash
On
Not defined
Slow flash
Slow flash
Offline for download
Slow flash
Fast flash
Restricted offline mode, waiting for
restart
Slow flash
Flashing
Restricted offline mode, test active
Fast flash
Off
Debug monitor in restricted mode
Fast flash
On
Not defined
Fast flash
Slow flash
Debug monitor in test fixture mode
Fast flash
Fast flash
Debug monitor in remote debug
mode
Fast flash
Flashing
Not defined
PCIe2 4-port 1 GbE Adapter (FC EL4L and EL4M; CCIN 576F)
Learn about the specifications and operating system requirements for the feature code (FC) EL4L and
EL4M adapters.
Overview
FC EL4L and EL4M are both the same adapter with different feature codes. FC EL4L is a low-profile
adapter and FC EL4M is a full-height adapter.
The PCIe2 LP 4-port 1 GbE Adapter is a full-height, generation 2 (Gen2) PCIe adapter. This adapter
provides four 1-Gb Ethernet ports that can be configured to run at 1000 megabits per second (Mbps) or 1
gigabit per second (Gbps), 100 Mbps, or 10 Mbps. The adapter connects to a network that uses
unshielded twisted pair (UTP) cable for distances of up to 100 meters (328.08 feet). The adapter supports
AIX Network Installation Management (NIM) boot capability and conforms to the IEEE 802.3ab
1000Base-T standard. The adapter also supports jumbo frames when running at the 1000 Mbps speed.
Each of the Ethernet ports can be connected by using:
v
CAT5e (or later) UTP cables for 1000 Mbps network attachment
v
CAT5 or CAT3 UTP cables for 100 Mbps or 10 Mbps network attachment
68
Installing the System and Ordered Parts for the 8335-GCA or 8335-GTA
Summary of Contents for S822LC
