IBM RackSwitch G8264T, Installation Manual, Page: 43 / 64

© Copyright IBM Corp. 2012 Chapter 2. Installing the RackSwitch G8264T
29
Initializing the RackSwitch G8264T
When you supply power to the RackSwitch G8264T, the switch initializes
automatically.
(L003)
The following LEDs indicate the overall system status:
•
Power Supply: Steady green if both power cords are connected, flashing green if
only one power cord is connected.
• Service ( ! ): Off if system is OK, flashing if service is required.
Use the mini-USB console cable to connect the RS-232 serial port on the switch
unit’s front panel to a terminal or a computer running a terminal emulation program.
You can access the command-line interface to perform initial configuration tasks.
The console port terminal-emulation requirements are as follows:
•
Default baud rate = 9,600 bps
• Character size = 8 characters
• Parity = none
• Stop bits = 1
• Data bits = 8
• Flow control = none
The switch performs initial self tests, and displays the
Password:
prompt, similar to
the following screen:
DANGER
Multiple power cords. The product might be equipped with multiple power
cords. To remove all hazardous voltages, disconnect all power cords.
Memory Test ................................
Production Mode
PPCBoot 0.0.0.10 (new flash)
Memory Test (0x00) .............................PASSED
...
IBM System Networking RS 8264T
Jan 1 00:01:27 2012:
NOTICE-5:Interface Oper Status Indication - Port 7 State UP
Password:
1 2