IBM QS21 - BladeCenter - 0792, Service Manual

Page: 107 / 144

Table 19. Other error messages (continued)
Code Message Description Action
E1003 Firmware image incomplete The firmware detected missing
components and cannot continue
execution.
The boot watchdog automatically
boots the system from the
permanent flash side. The
malfunctioning firmware image
should be rejected as described in
“Recovering the TEMP image from
the PERM image” on page 59.
Power down then reboot the
blade. If the problem persists,
contact your IBM service
representative as the system
board assembly may need
replacement.
E1004 Unspecified Internal Firmware
Error
The firmware encountered an
unexpected error condition.
The boot watchdog automatically
boots the system from the
permanent flash side. The
malfunctioning firmware image
should be rejected as described in
“Recovering the TEMP image from
the PERM image” on page 59.
Power down then reboot the
blade. If the problem persists,
contact your IBM service
representative as the system
board assembly may need
replacement.
BMC firmware messages
The following is a description of the BMC firmware messages that are sent to the
Advanced Management Module. Use the Advanced Management Module Web
interface to view them.
No codes are associated with these messages. However, the status column
indicates their severity.
There are three levels of severity:
Information
Informational messages only. No action need be taken, but you should
continue to monitor the item concerned.
Warning
A potentially serious error has occurred. The BMC has taken the action
described in the Automatic action column on the Advanced Management
Module but you may be required to take further action. See the appropriate
sections of this chapter indicated in Table 20 on page 90 for further
information
Error A serious error has occurred. The blade server may have been powered off
or rebooted. See the specific error for what action is required.
Chapter 5. Diagnostics and troubleshooting
89