IBM Proventia Management SiteProtector SP1001, Hardware Configuration Manual

Page: 36 / 64

SiteProtector SP1001 Appliance Configuration Checklist
The process of configuring the SiteProtector SP1001 appliance hardware requires
that you perform tasks in a certain order. Follow the steps in this topic when you
configure the SiteProtector SP1001 appliance.
Prerequisites
Before you configure your SiteProtector SP1001 appliance, you must have
completed the following tasks:
v Ensure that you meet the requirements for configuring the SiteProtector SP1001
appliance.
See “Requirements and Considerations” on page 8.
v
Gather the initial configuration items, including cables and network information.
See “Pre-configuration Checklists” on page 10.
Checklist
Use the checklist in the following table as a guide to help you perform the tasks in
this chapter. The check boxes are provided as a convenience to help you check off
the tasks as you complete them:
U
Task Description
h
1 Connect the cables and start the SiteProtector SP1001 appliance.
See“Connecting the SiteProtector SP1001 Appliance” on page 15.
h
2 Specify network information, such as IP addresses, gateways, and subnet
masks.
See “Configuring the SiteProtector SP1001 Appliance to Communicate with
the Network” on page 15.
h
3 Download, install, and point the SiteProtector Console to the SiteProtector
SP1001 appliance.
See “Installing and Starting the SiteProtector Console” on page 17.
12
SiteProtector System: SP1001 Hardware Configuration