Starting a system by using the control panel
You can use the power button on the control panel to start a system that is not managed by a Hardware
Management Console (HMC).
To start a system by using the control panel, complete the following steps:
1.
Open the front rack door, if necessary.
2.
Before you press the power button on the control panel, ensure that power is connected to the system
unit as follows:
v
All system power cables are connected to a power source.
v
The power LED, as shown in the following figure, is slowly flashing.
v
The top of the display, as shown in the following figure, shows
01 V=F
.
3.
Press the power button (A), as shown in the following figure, on the control panel.
v
A
: Power-on button
– A constant light indicates full system power to the unit.
– A flashing light indicates standby power to the unit.
– There is approximately a 30-second transition period from the time the power-on button is
pressed to when the power LED goes from flashing to solid. During the transition period, the
LED might flash faster.
v
B
: Enclosure identify light
– A constant light indicates the identify state, which is used to identify a part.
– No light indicates that the system is operating normally.
v
C
: System information light
– No light indicates that the system is operating normally.
– Light on indicates that the system requires attention.
v
D
: Enclosure fault roll-up light
A
B
C
D
E
F
G
H
I
J
Front View
Top View
P8HB5500-1
Figure 11. Control panel
14
Power Systems: Chassis management card for the EMX0 PCIe Gen3 I/O expansion drawer
Summary of Contents for Power Systems EMX0 PCIe Gen3
