IBM PCI Dual Channel Ultra2 SCSI Adapter, Installation And User Manual

Page: 24 / 50

g. Move the cursor to fileset names and type:
devices.pci.ðð1ððbðð
h. Press Enter to start the SPOT update. This operation can take up to
15 minutes.
i. Repeat steps "g" and "h" for all devices you want to install.
devices.pci.ðð1ðð1ðð
devices.pci.ðð1ððfðð
devices.common.IBM.scsi
13. Check if the software is already installed on the node(s) by typing at the
system prompt
dsh "lslpp -l devices.pci.ðð1ððbðð\ 2
>
&1" |more
dsh "lslpp -l devices.pci.ðð1ðð1ðð\ 2>&1" |more
dsh "lslpp -l devices.pci.ðð1ððfðð\ 2>&1" |more
dsh "lslpp -l devices.common.IBM.scsi\ 2>&1" |more
14. If the device driver is already installed on the Node, contact your service
provider to have the adapter installed.
15. If the device driver is not installed on the Node, proceed to section “Install
Device Drivers on the SP System Nodes” on page 4-6.
Installing Software on the Control Workstation
Note: If your system is "partitioned" (i.e. there are more than one operating system
among the nodes), you may only install this adapter in nodes that have 4.3.3 and
higher.
1. If you are not logged into the Control Workstation as root, log in now. You
may also need to export the working collective. Refer to section “Check
System Pre-Requisites” on page 4-1.
2. Insert the installation media into the Control Workstation's drive.
3. Transfer the files to the Control Workstation's lppsource, as follows:
a. Type
smitty bffcreate
then press Enter.
b. Select the input device/directory. Press F4 then move the cursor to
the appropriate input device and press Enter.
c. Move the cursor to the "SOFTWARE package to copy" option and
press F4 to select the software to be installed. Use the F7 key to
select the following device driver(s):
4-4
PCI Dual Channel Ultra2 SCSI Adapter Installation and User's Guide