IBM Nways 8260, Manual

Page: 312 / 354

This parameter determines if the RIP filter table will be used for
importing routes found by RIP. RIP filter table is discussed later in this
section.
• Import Static Routes
This parameter determines if the static route filter table will be used for
importing static routes. Static route filter table is discussed later in this
section.
• Default Action on No Match for RIP Routes
This parameter specifies the action to be taken when a RIP route does
not match any entry in the RIP filter table. If this parameter is set to
import, a route found by RIP that does not have a match in the RIP filter
table is imported using the default hop-to-metric conversion table.
Otherwise, it is not imported. Hop-to-metric conversion table is
explained later in this section.
• Default Action on No Match for Static Routes
This parameter specifies the action to be taken when a static route does
not match any entry in the static route filter table. If this parameter is set
to
import, a static route that does not have a match in the static route
filter table is imported using the default hop-to-metric conversion table.
Otherwise, it is not imported.
2. Define the interfaces that are enabled for OSPF. To do so, you must select
OSPF Interface Table from the OSPF Menu. An example of the resulting
panel is shown in Figure 170.
Config * OSPF Interface Table Module: BladeRunner
System Page 1 Time: 17:40 11 Jan 95
IP Address Port Area ID Type AdminStat Priority PollInt
9.67.46.17 0 0.0.0.0 broadcast Disabled 1 120
9.67.46.44 0 0.0.0.0 broadcast Enabled 1 120
9.67.46.94 0 0.0.0.0 broadcast Disabled 1 120
Modify Entry Prev Page Next Page Exit
Return to the previous screen
Figure 170. LMS OSPF Interface Table Panel
This table allows you to specify the OSPF-specific information about the
interfaces. Note that you cannot create or delete entries on this table. They
290
8260 Multiprotocol Intelligent Switching Hub