IBM Netfinity ServeRAID-4H Ultra160, User Reference

Page: 48 / 192

Installing device drivers while installing the operating system
This section provides instructions for installing the device drivers while installing the
operating system.
When using: Go to:
Windows 2000 “Installing device drivers for Windows 2000”.
Windows NT “Installing device drivers for Windows NT 4.0”.
NetWare “Installing device drivers for NetWare” on page 35.
Linux “Installing device drivers for Red Hat Linux 6.1(or later)” on page 35.
OS/2 “Installing device drivers for OS/2” on page 36.
OpenServer “Installing device drivers for OpenServer” on page 38.
UnixWare “Installing device drivers for UnixWare” on page 39.
Installing device drivers for Windows 2000
You must install the ServeRAID device driver on the Windows 2000 CD while
installing Windows 2000. The Windows 2000 installation program does not allow
you to upgrade a device driver that ships on the Windows 2000 CD. After installing
Windows 2000, you must update the ServeRAID device driver to the latest version,
which is on the IBM ServeRAID Support CD and the IBM ServeRAID Device
Drivers diskette. Refer to “Installing device drivers after installing Windows 2000” on
page 42.
Installing device drivers for Windows NT 4.0
To install the ServeRAID device driver while installing Windows NT 4.0:
1. Insert one of the following:
v
The Windows NT startup (boot) diskette into the diskette drive
v
The startable Windows NT CD into the CD-ROM drive;
then, restart the server.
Note: If you are installing on an IBM Netfinity server that supports Hot-plug PCI
under Windows NT 4.0, select the IBM ServeRAID Hot Replace Wizard
to enable the hot-replace operation.
2. When the message
Setup is inspecting your computer's hardware
configuration...
appears, press the F6 key.
3. After loading some files, Windows displays a screen where you can manually
specify a controller. When this screen appears, press the S key to specify
additional devices.
4. When prompted in the next window, select Other from the list.
5. When prompted to insert the
Manufacturer-supplied hardware support disk
,
insert the IBM ServeRAID Device Drivers diskette into the diskette drive; then,
press Enter.
6. If you are installing Windows NT 4.0, select IBM ServeRAID Controller (NT
4.0); then, press Enter. A message similar to the following will appear:
Setup is loading files (IBM ServeRAID Controller (NT 4.0))...
7. When prompted, press Enter to continue.
8. Use the instructions provided in the Windows NT manual to complete the
normal installation process.
9. After you complete the installation, be sure to install the latest Service Pack.
34
IBM
®
Netfinity
®
User’s Reference: ServeRAID
™
-4H Ultra160 SCSI Controller