IBM Netfinity FASt T500, User Reference

Page: 31 / 91

Chapter 2. Operating the controller unit 11
Accessing the controls
To access the controllers, battery, controller fan, and indicator lights, you must remove the
controller unit bezel, as shown in
Figure 6 .
Attention: Pulling the cover out too far can damage the plastic hooks at the top. To
avoid damaging the hooks, place the controller unit on a flat surface. Be sure
the front of the controller unit extends beyond the edge approximately 5 cm
(2 in.).
1 Carefully pull the bottom of the bezel out to release the pins; then slide the bezel down,
as shown in the following figure.
Figure 6. Removing the controller unit bezel
2 To replace the bezel, slip the top edge of the bezel under the lip on the chassis, then
push the bottom of the bezel until the pins snap into the mounting holes, as shown in
the following figure.
Figure 7. Replacing the controller unit bezel
Bezel
Bezel