Setup
3-8
3.2.4
Printing the Current Settings
This is done from the VIEW point.
Prerequisite 1: Loading a Document has been performed.
Prerequisite 2: Moving to VIEW has been performed.
1. Button Bar
-
press and hold down until the document
is advanced and printing begins.
Note: When printing has finished the document will be ejected forward over the
Document Guide.
3.2.5
Changing a Setting
In the following example the Print Quality parameter is changed from the factory
default Value of DRAFT to HQD (High Quality Draft).
1. Enter Setup
-
perform Entering Setup.
2. Load a Blank Document
-
perform Loading a Blank
Document.
3. Tab Horizontally, TWICE
-
the Skid points to the IBM Menu.
4. Select IBM
-
press and hold down the Button
Bar until the engine runs and the
document moves,
•
Print functions follow and the list, CURRENT SETTINGS, will be visible.
5. Tab Vertically, 2 TIMES
-
the FONT values DRAFT and
HQD are visible.
6. Tab Horizontally, 2 TIMES
-
the Skid points to <>HQD.
LOAD the selection
-
press and hold down the Button
Bar until the engine runs and
the document moves,
•
HQD is printed between FONT and DRAFT and the Skid performs a
vertical tab.
7.
Tab Vertically, 8 TIMES
-
the CONFIRM values, yes and
no are visible.
8.
Tab Horizontally, 1 TIME
-
the Skid points to the ‘yes’ option.
9.
Button Bar
-
press for longer than 2 seconds,
•
The new configuration is stored, print functions follow and the document
is returned forward over the document guide.