IBM InfoPrint Color 100, Introduction And Planning Manual

Page: 51 / 74

Chapter 6. Checklist
Use the following checklist to plan for the installation of the InfoPrint Color 100. The checklist should be
started when the printer is ordered. The first column of the checklist shows the number of weeks before
installation to accomplish the tasks.
The checklist is intended for use by the customer and IBM.
Table 10. Systems Assurance Checklist
Weeks Before
Install
Task Task Owner Yes/No Due Date Date
Done
8-12 Have you reviewed with the customer, and
covered the following points?
v
Temperature and humidity requirements
v
Ventilation
v
Heat dissipation and cooling
v
Acoustic levels
8-12 Check the flooring at the installation site. See
“Flooring Requirements” on page 20.
8-12 Have all spaces and clearances been verified
for moving the crates between the loading
dock and the printer installation site? See
“Shipping Crate Weights and Dimensions” on
page 20.
8-12 Is training for service representative
scheduled?
8-12 Is operator training scheduled?
4-6 Is a system engineer assigned for support?
4-6 Is training for a system engineer scheduled?
4-6 Have you reviewed supply requirements with
the customer?
4-6 Has the customer ordered and obtained
supplies?
1. Paper
v
Correct paper size
v
IBM tested
v
Quantity
2. Toner
See “Toner” on page 29 for approximate
yields.
3. Toner waste bottles
4. Splicing tape
Two rolls of paper and two bottles of each
color toner are shipped with the printer. One
roll of splicing tape is shipped with the
printer. Some of these supplies will be
consumed during installation and setup.
© Copyright IBM Corp. 1998
37