IBM ILM300, User Manual

Page: 14 / 66

3. Make sure the projector is unplugged and your computer is turned off.
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
— Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
— Connect all power cords to a properly wired outlet.
— Connect to properly wired outlets any equipment that will be attached to this product.
— When possible, use one hand only to connect or disconnect signal cables.
— Never turn on any equipment when there is evidence of fire, water, or structural damage.
— Disconnect the attached power cords, telecommunications systems, networks, and modems before you open
the device covers, unless instructed otherwise in the installation and configuration procedures.
— Connect and disconnect cables as described in the following table when installing, moving, or opening covers
on this product or attached devices.
To connect: To disconnect:
1. Turn everything OFF. 1. Turn everything OFF.
2. First attach all cables to devices. 2. First, remove power cords from outlet.
3. Attach signal cables to connectors. 3. Remove signal cables from connectors.
4. Attach power cords to outlet. 4. Remove all cables from devices.
5. Turn device ON.
Note: If you are connecting the projector to a computer, make sure that the distance between the
computer and the projector is 6 feet or less.
1
Audio in
2
S-Video
3
Video
4
Computer/USB mouse
Connecting a computer to the projector
The projector comes with an computer cable. If your computer has a digital output port, you can use the
optional digital computer cable, which is sold separately. See “Accessories” on page 25 for ordering
4
IBM iLM300 MicroPortable Projector: User’s Guide