IBM ILC200, User Manual

Page: 30 / 76

When Video standard is set to Auto , the projector attempts to select the video
standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL-60, or SECAM)
automatically based on the input signal that it receives. (The video standard
options might vary depending on your region of the world.) The input signal
for SECAM video is similar to other video signals and cannot be automatically
detected; therefore, SECAM must be selected manually. If the projector is
unable to detect the correct standard, the colors might not be displayed
correctly or the image might appear broken. If this happens, manually select a
standard by clicking the left or right navigation button and cycling through the
standards.
Note: If you already know the video standard that is used in your
geographical area, it is often best to manually select it.
Standby time
Use this option to select how long the lamp stays on and the blank screen is
displayed when the projector enters standby mode before the projector turns
off. Select among instant, 1, 5, 10, 15, and 30 minutes, and 1 and 2 hours by
clicking the left or right navigation button and cycling through the options.
Rear projection
When you turn
Rear Projection
on, the projector reverses the image so that
you can project from behind a translucent screen. Highlight Rear Projection ,
and then click the left or right navigation button to turn this feature on and
off.
Default source
Use the Default source option to select among Computer analog , Computer
digital , and Video . This determines which source the projector checks first for
active video during power-on. Highlight
Default source,
and click the left or
right navigation button to select among the options.
Auto source select
Use this setting to select between
On
and
Off
. When this feature is off, the
projector defaults to the source that is selected in Default source . To display
another source, you must manually select one by pressing the source button on
the keypad or the computer or video button on the remote control. When this
feature is on, the projector automatically finds the active source, checking the
default source first. Highlight
Auto source select and click the left or right
navigation button to turn this feature on and off.
Plug and Play
1-22
iLV200/iLC200 IBM Data/Video Projector: User’s Guide