IBM ILC200, User Manual

Page: 12 / 76

Attention: Do not look directly into the projection lens when the lamp is
turned on. The bright light might harm your eyes.
Attention: Do not block the grills on the projector. Restricting the airflow can
cause it to overheat and turn off. If this happens, you must wait a minute
before attempting to turn it back on.
v
Handle the projector as you would any product with glass components. Be
especially careful not to drop it.
v
Avoid leaving the projector in direct sunlight or extreme cold for extended
periods of time. If this happens, allow it to reach room temperature before
use.
v
Transport the projector in a carrying case. Refer to Appendix A to determine
what accessories are available for your projector.
Setting up the projector
Use the following procedure to set up the projector:
1.
Place the projector on a flat surface.
v
The projector must be within 10 feet (3 m) of your power source and
within 6 ft. (1.8 m) of your computer.
v
If you want to project from behind a translucent screen, set up the
projector behind the screen. See “Rear projection” on page 1-22 for
instructions for reversing the image.
2. Position the projector the desired distance from the screen.
v
The distance from the lens of the projector to the screen and the zoom
setting determine the size of the projected image. The following
illustration shows three projected image sizes. For more information
about image size, see Appendix D,
″
Projected image size,
″
on page 15.
1-4
iLV200/iLC200 IBM Data/Video Projector: User’s Guide