IBM FC 2704, Installation Instructions Manual

Page: 24 / 56

__ d.
Push the mounting bracket into the slide rail end, until the spring-loaded pin snaps into
place.
__ e. If the cable management arm was installed, use a cable tie to secure the free end of the cable
management arm to the EIA frame on the rack.
__ 5. See Figure 14 on page 19. To install the cable management arm assembly:
__ a. Place the arm assembly on the support arm.
__ b. Pull the spring loaded arm assembly pin
▌1▐
.
__ c. Slide the cable management arm tab
▌2▐
into the slot on the inside of the slide rail.
__ d. Push in on the arm assembly tab until it snaps into place.
__ e. Pull the other spring loaded arm assembly pin
▌3▐
.
__ f. Slide the arm assembly tab into the slot
▌4▐
on the outside of the slide rail end.
ts760656
1
2
3
Figure 13. Attaching the mounting bracket to the slide rail
18
FC 2704, 2725, 2748, & 5512