IBM EXN1000, Hardware And Service Manual

Page: 54 / 94

Table 7. AT-FCX console error messages
Error message Action required
Temperature sensor 2:
failed
Contact IBM customer service to replace the module.
Temperature sensor 3:
failed
SES electronics Element 1:
component is from a
different product family
This configuration is unsupported. Contact IBM
customer service to replace the module.
SES electronics
Element 1: failed
Contact IBM customer service.
SES electronics
Element 2: failed
The AT-FCX module on the expansion unit failed.
Contact IBM customer service to replace the module.
Temperature sensor 2: not
installed or failed
Contact IBM customer service.
Environmental sensor 3: not
installed or failed
SES electronics Element 1:
not installed or failed
Vendor-specific Element 1:
not installed or failed
SES electronics
Element 2: not
installed or failed
Communication with the temperature sensor on the
AT-FCX module failed. Replace the AT-FCX module as
described in “Hot-swapping a module” on page 37.
Vendor-specific
Element 2: not
installed or failed
Monitoring the power supply
The power supply has four LEDs. The LEDs indicate whether the power
supply or the integrated fan module is functioning normally or there are
problems with the hardware. You can also identify any hardware failure
associated with the power supplies from the error messages displayed on
your N series storage system console.
The following illustration is of the third sheet of the quick reference cards that
comes with your EXN1000 expansion unit.
24