IBM eserver p Series, Installation Manual

Page: 31 / 76

Step 9. Setting Up Attached Devices
Note: During the setup of each device, connect only the device end of the signal cable.
Do not connect the device signal cables to the rack now.
Do the setup procedures in the documentation provided for each device being
attached to the rack. Then return to “Step 10. Updating the Device Records”.
Connect the ASCII terminal to serial port 1 (S1). Connect the keyboard (K), mouse (M),
and graphics display (if available). Refer to the following figure for the locations of the
connectors.
Step 10. Updating the Device Records
Update the “System Records” in Appendix D, “System Records” on page 47 to reflect
the configuration of the system adapters and devices that are installed.
Step 11. Attaching External Devices
External devices used with the system are connected to connectors on the I/O drawers
or to adapters that are installed in any of the I/O drawers. Attach any external devices
now.
K M S1
1 2 3 4 5 6 14 13 12 11 10 9 8 7
P1
Ethernet
SCSI Parallel
Chapter 1. Setting Up the System
17