IBM eserver iSeries 270, Installation Manual

Page: 24 / 40

__ 2. Refer to the figure that matches your system unit to place the memory in
the correct order.
__ 3. Place memory cards as follows on the processor:
v
In pairs, beginning with C and D , then E and F , and so on.
v
Each pair of storage cards must be either 128 MB, 256 MB, 512 MB, or 1
GB.
__ 4.
Remove the blank filler cards from the next available positions by doing
the following:
__ a. Push outward on the latches that are located at each end of the filler
card, Figure 17 on page 19.
__ b. Remove the filler card from the card socket and discard it.
__ 5. Find the package that contains the new memory cards.
__ 6. Attention: Memory cards are fragile. Handle with care.
Remove a memory card, one at a time , from the static protective package.
__ 7. Install the memory card in the next available position beginning with C
and D
by doing the following:
__ a. Look carefully at the notches on the bottom of the memory card. The
distance between the notches and the end of the card is slightly
different.
__ b.
Align the card as shown in Figure 17 on page 19 or Figure 18. Push
forward on the card until the latches close.
Figure 18. Memory Connectors View 2
20
30xx Memory Card Installation V5R2