IBM eServer 380 xSeries, User Reference Manual

Page: 26 / 112

12
xSeries 380: User’s Reference
Turning on the server
This section provides information about how to turn on the server again after the initial
startup has been completed.
Complete the following steps to start the server:
1. Verify that the power cords are plugged into a PDU.
2. Turn on the monitor by pressing the monitor power-on button.
3. Press the power-control button on the front panel of the server. See “Server
controls and indicators” on page 7 for the location of this button.
Attention: If the following message displays during POST, press Reset before
continuing system startup:
Turning off the server
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power
source.
ERRORS FOUND IN MEMORY SUBSYSTEM, FAILING ROWS WILL BE MAPPED OUT ON THE NEXT
RESET. IT IS STRONGLY SUGGESTED THAT YOU RESET THE SYSTEM NOW
.
ALLOWING THE SYSTEM TO CONTINUE TO BOOT MAY RESULT IN UNSTABLE SYSTEM BEHAVIOR
AND/OR HARD DISK CORRUPTION
Hit F1 to load defaults or F2 to run setup or ESC to continue
1
2