IBM EN4093R, User Manual

Page: 22 / 60

Attention: To avoid damage to the cable or the modules, make sure that you
disconnect the fiber-optic cable before you remove the SFP+ or QSFP+
modules.
4. Unlock the module by pulling the wire tab straight out, as shown in the following
illustration.
5. Grasp the wire tab on the module and pull it out of the port.
6. Replace the protective cap on the module and the SFP+ or QSFP+ module
port.
7. Place the module into a static-protective package.
Cabling the switch, the SFP+ and the QSFP+ module
This section describes how to connect and disconnect various cables to supported
switch modules. For information about the supported cables and modules, see
Parts listing.
Note: The illustrations in this document might differ slightly from your hardware.
Connecting the serial console cable
To connect the serial console cable to the switch, connect the serial cable to the
RS-232 serial console port of the switch and the other end of the cable to the
console device.
Note: You must use one of the two cables provided in the Serial Access Cable
option (see “Cabling the switch, the SFP+ and the QSFP+ module.”
If your attached console device uses a standard RS-232 DB9 connection, attach
serial cable (part number: 43X0509). If your attached console device uses a RJ-45
connection, attach serial cable (part number: 90Y9338) and a user supplied RJ-45
coupler and adapter cable. Your adapter cable depends on the pin out required by
your console device. Pin out of the 90Y9338 cable is as follows:
Table 1. Pin out for 90Y9338 cable
Pin # Function Direction
1 N/C -
2 RXD In
3 TXD Out
4 GND -
5 GND -
6 N/C -
12
EN4093 and EN4093R 10 Gb Scalable Switch: User's Guide