IBM Elastic Storage System 3200, Service Manual

Page: 29 / 64

Removing and replacing a bezel kit
Refer to the service procedure to remove and replace both left and right ear caps in an IBM Elastic
Storage System 3200 enclosure.
The following steps are the high-level flow of the procedure:
1. Unlock the enclosure from the rack.
2. Pull enclosure from the front until it reaches the serviceable position.
3. Remove and replace the left ear cap.
4. Remove and replace the right ear cap.
5. Return enclosure back to the rack position.
6. Secure the enclosure in the rack.
7. Place the IBM brand label on the right ear cap.
Note: If you encounter an error or an unexpected result, contact the next-level support.
This service procedure requires front service access. Replacing system bezel kit for an IBM Elastic Storage
System 3200 enclosure requires that the enclosure is extended from the rack in the serviceable position.
Take precautions to avoid damage from static electricity. When you remove or replace
parts throughout this process, you must follow recommended procedures for handling ESD sensitive
devices.
To replace the bezel kit for IBM Elastic Storage System 3200, you require the following tools:
• #2 Phillips driver to loosen the shipping screws and remove bezel ear caps.
The following parts are included in the kit to perform the service procedure:
• Left bezel ear cap (Part number - 01LL677)
• Right bezel ear cap (Part number - 01LL678)
• 4x spare bezel screws (Part number - 97P4941)
• IBM IBM Elastic Storage System 3200 brand badge
Refer to the following steps to remove and replace ear caps:
1. Unlock the enclosure from the rack.
Loosen the left and right shipping screws that secure the enclosure to the rack posts, as highlighted in
Figure 27 on page 17.
Figure 27. Showing enclosure front view with shipping screws
2. Pull enclosure from the front until it reaches to the serviceable position.
Chapter 1. Servicing (customer tasks) 17