IBM DCS3860, Installation, User'S, And Maintenance Manual

Page: 97 / 204

a. Hold the release lever with orange attachment and open it. Both the release
levers open. The controller moves out of the bay approximately 1 cm (0.4
inch).
b. Hold both the release levers and pull the controller out of the enclosure.
c. Place the controller on a level surface.
Attention: After you remove a controller, wait for 90 seconds before you reseat or
replace the controller. Failure to do so might cause unpredictable results.
Removing and installing a cover
Before you begin:
v
Read the "Safety" and "Best practices guidelines" sections of this document.
v
Ensure that you wear an anti-static wrist strap.
Complete the following steps to remove a cover from a controller:
1. Press the two release buttons and slide the cover toward the rear of the
controller.
Release
levers
dcsi0059
AC
DC
2
1
I
O
Port 2
Port 1
ID/
Diag
1
Ho
st C
ard
Figure 36. Removing a controller
Chapter 5. Replacing components
79