IBM DCS3860, Installation, User'S, And Maintenance Manual

Page: 109 / 204

6. Install the DDM by completing the following steps:
Note: The DDM comes installed in a drive enclosure. Do not attempt to detach
the DDM from the enclosure.
a. Raise the drive handle to the vertical position, as shown in Figure 46.
b. Align the two raised buttons on each side over the matching gap in the
drive channel on the drawer, as shown in Figure 47.
c. Lower the drive straight down; then, rotate the drive handle down until the
drive snaps into place under the drive release lever. See Figure 48 on page
92
Latch
drive bay slots
Raised
buttons
Slightly press here
while pushing the
lever down to lock
the drive
dcsi0036
Figure 45. Inserting a hard disk drive into the connector
Figure 46. Raising the drive handle
Raised
buttons
Figure 47. Aligning the drive
Chapter 5. Replacing components
91