IBM BladeCenter HC10 Type 7996, Installation And User Manual, Page: 35 / 74

Closing the blade workstation cover
Important: The blade workstation cannot be inserted into the BladeCenter unit until
the cover is installed and closed. Do not attempt to override this protection.
The following illustration shows how to close the blade workstation cover.
Blade-cover
release
Blade-cover
release
Cover
pins
To close the blade workstation cover, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 15.
2. If you removed the blade bezel assembly, replace it now (see “Installing the
blade workstation bezel assembly” on page 22 for instructions).
3. Make sure that all components are installed and seated correctly and that you
have not left loose tools or parts inside the blade workstation.
4. Make sure that the control-panel cable and all other cables are placed so that
the cover does not crimp or pinch them.
5. Lower the cover so that the slots at the rear slide down onto the pins at the rear
of the blade workstation, as shown in the illustration.
6. Pivot the cover to the closed position, as shown in the illustration, until it clicks
into place.
Chapter 3. Installing optional devices
23