IBM AnyPlace 4836, Planning, Installation And Service Manual

Page: 58 / 108

Removing the LCD
1. Remove the covers as described in “Removing the back cover” on page 28.
2. Remove the eight screws (
A
) holding the system board (main planar) and
LCD assembly to the front bezel.
Note: You do not need to remove the system board from the LCD assembly to
remove the LCD.
3. Disconnect the following cables and connectors:
v
Touch cable (see
A
in Figure 27 on page 40)
v Speakers (see
B
in Figure 24 on page 37)
v
Control card cable (see
B
in Figure 27 on page 40)
v
LCD backlight connectors (2) (see
A
in Figure 28 on page 41)
4. Remove the LCD assembly (includes system board).
Note: Take care not to bend the metal antenna (
B
in Figure 29).
5. Turn the LCD assembly over to locate and remove the four screws holding the
LCD to the back of the LCD assembly. Remove the LCD.
6. Disconnect the main signal cable from the back of the LCD.
A
B
Figure 29. Removing the LCD
42
Anyplace Kiosk 4836