IBM Ambra Achiever 5000, Hardware Manual

Page: 53 / 78

Chapter 4. Troubleshooting (SSR tasks)
This section will help you to troubleshoot issues that are faced while configuring EMS and Elastic Storage
System 5000.
Note: Ensure that you have gone through the “Installation prerequisites (SSR task)” on page 28 topic and
also followed the steps given in the “Installation steps (SSR task)” on page 28 topic.
EMS issues
EMS Boot issues
When booting up the node, if you face any issue while pinging the FSP interface (C11-T4 IP
110.111.222.101) 5 minutes after pressing the white button, perform the following checks:
• Verify if the Ethernet cable on both the ends has a solid green light.
• Check if your laptop is set to IP 10.111.222.102 and netmask 255.255.255.252.
• Verify that you are plugged into the correct port – C11-T4 on the EMS.
If the issues still persist, shut down the node (hold the white button until blinking again) and perform the
following steps:
1. Connect the laptop point-to-point over serial connection, connecting the USB to RJ45 console cable
between the auxiliary laptop and the serial port of the server with active ASMI session from the
previous section.
Note:
• The USB to RJ45 console cable shown in the Figure 20 on page 41 works for Linux and Windows
laptops.
• Identify the right console cable when using an Apple laptop.
Figure 20. Connecting a laptop to the serial port in the EMS node
2. Open a terminal emulator program such as PuTTY or minicom. Set the following settings for
communications using the serial connection:
19200 baud rate
Data bits of 8
©
Copyright IBM Corp. 2020 41