IBM AIX HACMP SG24-5131-00, Hardware User Manual

Page: 139 / 240

Cluster Customization
121
no actions since appropriate actions depend on
the local network configuration.
5.1.1.3 Network Adapter Events
swap_adapter
This event occurs when the service adapter on a
node fails. The swap_adapter event exchanges
or swaps the IP addresses of the service and a
standby adapter on the same HACMP network
and then reconstructs the routing table.
swap_adapter_complete This event occurs only after a swap_adapter
event has successfully completed. The
swap_adapter_complete event ensures that the
local ARP cache is updated by deleting entries
and pinging cluster IP addresses.
fail_standby This event occurs if a standby adapter fails or
becomes unavailable as the result of an IP
address takeover. The fail_standby event
displays a console message indicating that a
standby adapter has failed or is no longer
available.
join_standby This event occurs if a standby adapter becomes
available. The join_standby event displays a
console message indicating that a standby
adapter has become available.
5.1.1.4 Cluster Status Events
config_too_long
This event occurs when a node has been in
reconfiguration for more than six minutes. The
event periodically displays a console
message.
reconfig_topology_start This event marks the beginning of a dynamic
reconfiguration of the cluster topology.
reconfig_topology_completeThis event indicates that a cluster topology
dynamic reconfiguration has completed.
reconfig_resource_acquire This event indicates that cluster resources
that are affected by dynamic reconfiguration
are being acquired by appropriate nodes.
reconfig_resource_release This event indicates that cluster resources
affected by dynamic reconfiguration are being
released by appropriate nodes.