IBM AIX HACMP SG24-5131-00, Hardware User Manual

Page: 118 / 240

100
IBM Certification Study Guide AIX HACMP
2. If you wish to save your cluster configuration, see the chapter Saving and
Restoring Cluster Configurations in the HACMP for AIX, Version 4.3:
Administration Guide,
SC23-4279.
3. Commit your current HACMP for AIX software on all nodes.
4. Shut down one node (gracefully with takeover) using the
smit clstop
fastpath. For this example, shut down Node A. Node B will take over Node
A’s resources and make them available to clients.
See the chapter “Starting and Stopping Cluster Services” in the
HACMP
for AIX, Version 4.3: Administration Guide, SC23-4279, for more
information on stopping cluster services.
5. Install HACMP for AIX Version 4.3. See Chapter 8 of the HACMP for AIX,
Version 4.3: Installation Guide , SC23-4278, starting with the section
“Installation Choices”, for instructions.
The
cl_convert
utility automatically updates the HACMP ODM object
classes to the 4.3 version.
6. Reboot Node A.
7. Start the HACMP for AIX software on Node A using the
smit clstart
fastpath and verify that Node A successfully joins the cluster.
8. Repeat Steps 3 through 7 on remaining cluster nodes, one at a time.
9. After all nodes have been upgraded to HACMP Version 4.3, synchronize
the node configuration and the cluster topology from Node A to all nodes.
10.Verify the cluster topology on all nodes using the
clverify
utility.
11.Complete a test phase on the cluster before putting it into production.
4.2 Defining Cluster Topology
The cluster topology is comprised of the following components:
• The cluster definition
• The cluster nodes
• The network adapters
If IP address swapping is being used on this node, that is, a boot
address is defined for this node, check to ensure that the HACMP
changes to
/etc/inittab
and
/etc/rc.net
exist as specified in Appendix
A of the
HACMP for AIX, Version 4.3: Installation Guide
, SC23-4278,
before rebooting the node.
Note