13
DE
UTS
C
H
EN
GLI
S
H
F
R
ANÇAIS
ES
P
A
Ñ
O
L
IT
ALIA
NO
JAP
ANE
S
E
COMP
L & W
A
R
R
Manual Setup
Normally, you can complete the setup procedure using
A
UTO
S
ETUP
, however,
if your screen image is still distorted after you perform
A
UTO
S
ETUP
or the setup
diskette does not run on your system, perform
M
ANUAL
S
ETUP
.
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
To disable the Windows energy
saving feature by clicking on the
S
TART
button and selecting
S
ETTINGS
, C
ONTROL
P
ANEL
,
D
ISPLAY
, S
CREEN
S
AVER
. Make
sure that the E
NERGY
SAVING
FEATURES
OF
MONITOR
check
boxes are either empty, or that
the features are set to at least 20
minutes.
Your system may also have its
Power Saving utility enabled
through the Bios Setup Utility.
Refer to your system manual for
directions on disabling that bios
option.
1.
Have your computer and monitor turned on for at least 15 minutes until
the monitor and video adapter have warmed up.
2.
You may wish to start the program you most often use so that you can
adjust for a “typical” screen.
3.
Press the OSD Enter button
at the bottom of the monitor to display
the initial OSD menu.
4.
Use a Control button (
-
or
+
) to select the IMAGE LOCK icon
and
press the OSD Enter button
to access the function.
5.
Using a Control button (
-
or
+
), select
MANUAL
, press
and then
press (
▼
) once to select
COARSE
. Left and right arrow adjustment
indicators become illuminated (see page 17
).
6.
Use the Control buttons(
-
or
+
) to correct (as much as possible) for
noise in the video signal.
7.
Use a Control button (
▲
) to select
FINE
.
8.
Use the Control buttons again to tune the image to your liking.
9.
When finished, press the Exit button 3 times to exit from the OSD.
You have completed the monitor setup.
