IBM 92296GU - IntelliStation M - Pro 9229, User Manual

Page: 49 / 86

Removing the internal drive-bay bracket
To remove the internal drive-bay bracket, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 29.
2. Turn off the computer and all attached devices (see “Turning off the computer”
on page 19).
3. Remove the side cover (see “Removing the side cover” on page 35).
4. If a hard disk drive is installed in the bracket, disconnect the signal and power
cables from the hard disk drive.
5. Remove the two screws that fasten the top edge of the drive-bay bracket to the
chassis.
6. Grasp the lower edge of the drive-bay bracket, and disengage it from the
chassis.
7. Lift the top edge of the drive-bay bracket from the chassis and remove the
drive-bay bracket from the computer.
Screws
Alignment tabs
Chapter 4. Installing optional devices
37